ARCOM

Search or browse again.

Click on the titles below to expand the information about each abstract.
Viewing 26 results ...

Çıdık, M S and Boyd, D (2020) “Shared sense of purposefulness”: a new concept to understand the practice of coordinating design in construction. Construction Management and Economics, 38(01), 18–31.

Ahmad Shazali, A S and Tahar, K N (2019) Virtual 3D model of Canseleri building via close-range photogrammetry implementation. International Journal of Building Pathology and Adaptation, 38(01), 217–27.

• Type: Journal Article
• Keywords: UAV; Accuracy; 3D model; Close-range photogrammetry;
• ISBN/ISSN: 2398-4708
• URL: https://doi.org/10.1108/IJBPA-02-2018-0016
• Abstract:
  The current technique used to measure construction is the conventional total station method. However, the conventional method is time-consuming and could not be used to create a photo-realistic three-dimensional (3D) model of an object. Furthermore, the Canseleri building is located at a slope. The paper aims to discuss this issue. The aim of this study is to assess the geometric accuracy of a 3D model using unmanned aerial vehicle (UAV) images. There are two objectives in this study. The first is to construct a 3D model of the Canseleri building using UAV images. The second objective is to validate the 3D model of the Canseleri building based on actual measurements. The close-range photogrammetry method, using the UAV platform, was able to produce a 3D building model. The results show that the errors between the actual measurement and the generated 3D model were less than 4 cm. The accuracy of the 3D model achieved in this study was about 0.015 m, compared to total station measurements. Accuracy assessment was done by comparing the estimated measurement of the 3D model with the direct measurement. The differences between the measured values with actual values could be compared. Based on this study, the 3D building model gave a reliable accuracy for specific applications.

Amadi, A and Higham, A P (2019) A cost trajectory to environmentally adaptive building construction in wet humid settings. International Journal of Building Pathology and Adaptation, 38(01), 68–88.

Ashdown, M M, Crawley, J, Biddulph, P, Wingfield, J, Lowe, R and Elwell, C A (2019) Characterising the airtightness of dwellings. International Journal of Building Pathology and Adaptation, 38(01), 89–106.

Brooks, T, Scott, L, Spillane, J P and Hayward, K (2020) Irish construction cross border trade and Brexit: Practitioner perceptions on the periphery of Europe. Construction Management and Economics, 38(01), 71–90.

Brown, N, Wright, A J, Shukla, A and Stuart, G (2010) Longitudinal analysis of energy metering data from non-domestic buildings. Building Research & Information, 38(01), 91.

Crawley, J, Biddulph, P, Wingfield, J, Ashdown, M, Lowe, R and Elwell, C (2019) Inferring the as-built air permeability of new UK dwellings. International Journal of Building Pathology and Adaptation, 38(01), 3–19.

Crosbie, T and Baker, K (2010) Energy-efficiency interventions in housing: learning from the inhabitants. Building Research & Information, 38(01), 9.

Djebbar, K E, Salem, S and Mokhtari, A (2019) Assessment of energy performance using bottom-up method. International Journal of Building Pathology and Adaptation, 38(01), 192–216.

Erkoreka, A, Flores-Abascal, I, Escudero, C, Martin, K, Millan, J A and Sala, J M (2019) Flat roof hygrothermal performance testing and evaluation. International Journal of Building Pathology and Adaptation, 38(01), 148–75.

Firth, S K, Lomas, K J and Wright, A J (2010) Targeting household energy-efficiency measures using sensitivity analysis. Building Research & Information, 38(01), 25–41.

Flood, C and Scott, L (2019) Thermal analysis and post construction verification. International Journal of Building Pathology and Adaptation, 38(01), 51–67.

Gupta, R, Gregg, M and Cherian, R (2019) Developing a new framework to bring consistency and flexibility in evaluating actual building performance. International Journal of Building Pathology and Adaptation, 38(01), 228–55.

Hamidane, H, Ababneh, A, Messabhia, A and Xi, Y (2019) Modeling of chloride penetration in concrete structures under freeze-thaw cycles. International Journal of Building Pathology and Adaptation, 38(01), 127–47.

Ibraheem, Y, Piroozfar, P A, Farr, E R and Ravenscroft, N (2019) Methodological evaluation of Integrated Façade Systems. International Journal of Building Pathology and Adaptation, 38(01), 107–26.

Li, M, Allinson, D and Lomas, K (2019) Estimation of building heat transfer coefficients from in-use data. International Journal of Building Pathology and Adaptation, 38(01), 38–50.

Marsh, R, Larsen, V G and Kragh, M (2010) Housing and energy in Denmark: past, present, and future challenges. Building Research & Information, 38(01), 92–106.

O’Connell, S, Reynders, G, Seri, F, Sterling, R and Keane, M M (2019) A standardised flexibility assessment methodology for demand response. International Journal of Building Pathology and Adaptation, 38(01), 20–37.

Oswald, D (2020) Safety indicators: questioning the quantitative dominance. Construction Management and Economics, 38(01), 11–17.

Ponton, H, Osborne, A, Thompson, N and Greenwood, D (2020) The power of humour to unite and divide: a case study of design coordination meetings in construction. Construction Management and Economics, 38(01), 32–54.

Rogage, K, Clear, A, Alwan, Z, Lawrence, T and Kelly, G (2019) Assessing building performance in residential buildings using BIM and sensor data. International Journal of Building Pathology and Adaptation, 38(01), 176–91.

Shipworth, M, Firth, S K, Gentry, M I, Wright, A J, Shipworth, D T and Lomas, K J (2010) Central heating thermostat settings and timing: building demographics. Building Research & Information, 38(01), 50–69.

Summerfield, A J, Lowe, R J and Oreszczyn, T (2010) Two models for benchmarking UK domestic delivered energy. Building Research & Information, 38(01), 12–24.

Summerfield, A J, Pathan, A, Lowe, R J and Oreszczyn, T (2010) Changes in energy demand from low-energy homes. Building Research & Information, 38(01), 42–9.

Troje, D and Gluch, P (2020) Populating the social realm: new roles arising from social procurement. Construction Management and Economics, 38(01), 55–70.

van den Boomen, M, Spaan, M T J, Shang, Y and Wolfert, A R M (2020) Infrastructure maintenance and replacement optimization under multiple uncertainties and managerial flexibility. Construction Management and Economics, 38(01), 91–107.